comp.lang.idl-pvwave archive: archive » Re: Syntax Error Confusion

Home » Public Forums » archive » Re: Syntax Error Confusion

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Syntax Error Confusion [message #55487]

Fri, 24 August 2007 11:16

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Ryan. writes:

> Here is my snippet of code: (The only thing before this is some
> declaration of variables)
>
> IF getdata THEN $
> snrarray = getsnrarray(wnrange, occlist, DATESARR=time, $
> /JULIAN, $
> OCCS2RM=occs2rm, WAVENUMS=wavenums) && $
>
> occ1snr = REFORM(snrarray[0,*]) && $
> occ2snr = REFORM(snrarray[1,*])

Your problem is this is NOT the way to write a BEGIN-END
block of code. In fact, you are forgetting the BEGIN and the END :-)

Are you SURE you want to be doing this in a batch file!?
Maybe there is an easier way. May I suggest a main-level
program. Then you don't have to jump through all these
&& $ hoops to get something done.

Cheers,

David

P.S. A main-level program is just like a batch file, except
it has an END at the end of it, and you compile it before you
run it. But all the variables are available to you at the main
IDL level, where it runs.

IDL> .run myprogram

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/

Report message to a moderator

[Message index]

		Re: Syntax Error Confusion By: David Fanning on Fri, 24 August 2007 11:16
		Re: Syntax Error Confusion By: rchughes on Mon, 27 August 2007 06:18
		Re: Syntax Error Confusion By: Craig Markwardt on Fri, 24 August 2007 20:16

Previous Topic:	Re: How to get an arbitrary sectional slice in 3D array ?
Next Topic:	How to avoid the FOR loop when using TM_TEST?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 18:20:04 PDT 2025

Total time taken to generate the page: 0.00453 seconds