comp.lang.idl-pvwave archive: archive » Re: How to build ASCII File

Home » Public Forums » archive » Re: How to build ASCII File

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How to build ASCII File [message #56836]

Tue, 20 November 2007 09:49

Paul Van Delst[1]
Messages: 1157
Registered: April 2002

Senior Member

Marshad2@gmu.edu wrote:
> Hi Guys:
>
> I tried to make ASCII file for Spectral Response Curves obtained at
> ftp://asapdata.arc.nasa.gov/MASTER/srf/May_03/ however, it is not
> working. Can someone give suggestions how to build ASCII file for
> Spectral Response Curves.

Um.. all the files in the above link are already ASCII files.

What, exactly, are you trying to do?

cheers,

paulv

Report message to a moderator

Re: How to build ASCII File [message #56837 is a reply to message #56836]

Tue, 20 November 2007 09:25

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Marshad2@gmu.edu writes:

> I tried to make ASCII file for Spectral Response Curves obtained at
> ftp://asapdata.arc.nasa.gov/MASTER/srf/May_03/ however, it is not
> working. Can someone give suggestions how to build ASCII file for
> Spectral Response Curves.

I would say use PRINTF, just off the top of my head.
Just out of curiosity, what did you try that didn't work?

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

Previous Topic:	Re: how to representate (non constant) values in IDLgrAxis
Next Topic:	IDL code for DCAPE

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 12:57:15 PDT 2025

Total time taken to generate the page: 1.28181 seconds