comp.lang.idl-pvwave archive: archive » Simple question: promptusertext method

Home » Public Forums » archive » Simple question: promptusertext method

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Simple question: promptusertext method [message #58977 is a reply to message #58937]

Fri, 29 February 2008 13:30

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Wasit.Weather@gmail.com writes:

> Yes, I saved it in my hard drive, compiled and hit the run button. Is
> there any specific command to run it?

I wish they would just get rid of that *%@ run button!!

I hate to tell you this, but that good-for-nothing run
button only runs main-level programs and procedures that
take no arguments. That is to say, an *extremely*
small fraction of the IDL programs you plan to use. :-(

Try going to the IDL command line and typing this:

IDL> answer = TextBox()

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Simple question: promptusertext method By: Selim.Ta on Wed, 27 February 2008 13:37
		Re: Simple question: promptusertext method By: David Fanning on Fri, 29 February 2008 13:30
		Re: Simple question: promptusertext method By: Wasit.Weather on Fri, 29 February 2008 13:19
		Re: Simple question: promptusertext method By: David Fanning on Fri, 29 February 2008 12:23

Previous Topic:	Re: Overlaying a contour on a small image
Next Topic:	Re: Problem with Towler Camera Code

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 22:19:42 PDT 2025

Total time taken to generate the page: 1.34608 seconds