comp.lang.idl-pvwave archive: archive » Re: Locked-up workbench: ctrl-C doesnt work

Home » Public Forums » archive » Re: Locked-up workbench: ctrl-C doesnt work

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Locked-up workbench: ctrl-C doesnt work [message #59507]

Fri, 28 March 2008 09:03

R.G. Stockwell
Messages: 363
Registered: July 1999

Senior Member

"elwood" <epolomsk@uwsp.edu> wrote in message
news:6e6ba6f7-5c0e-4783-a79c-2f329e2686ee@i7g2000prf.googleg roups.com...
> On Mar 27, 11:15 pm, David Fanning <n...@dfanning.com> wrote:
...
> I'm reasonably sure its not an infinite loop
> because I had one guy add bunches of print statements,
> including some that were placed prior to any of his loops,
> immediately after the program started.

you may have to flush the prints.

Put in some stops. (at the beginning of the program,
since you seem to think it doesn't even start going,
and before and after the loop)

You could put a if counter gt 1000 then stop
inside the loop to see if you reach it (choose an appropriate number)

And print out a counter in the loop.

Cheers,
bob

Report message to a moderator

[Message index]

		Re: Locked-up workbench: ctrl-C doesnt work By: R.G. Stockwell on Fri, 28 March 2008 09:03
		Re: Locked-up workbench: ctrl-C doesnt work By: David Fanning on Thu, 27 March 2008 22:40
		Re: Locked-up workbench: ctrl-C doesnt work By: elwood on Thu, 27 March 2008 21:51
		Re: Locked-up workbench: ctrl-C doesnt work By: David Fanning on Thu, 27 March 2008 21:15

Previous Topic:	Need GOES Image Expert
Next Topic:	(simple question) PLOT, YTICKS in /YLOG AXIS

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Oct 28 00:24:04 PDT 2025

Total time taken to generate the page: 0.00197 seconds