comp.lang.idl-pvwave archive: archive » Locked-up workbench: ctrl-C doesnt work

Home » Public Forums » archive » Locked-up workbench: ctrl-C doesnt work

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Locked-up workbench: ctrl-C doesnt work [message #59516]

Thu, 27 March 2008 20:37

elwood
Messages: 23
Registered: February 2007

Junior Member

More than half a dozen times today my students managed to
irretrievably hang the IDL workbench.
They were running a while loop within their program.
No syntax error was issued, but when they ran the program it would not
execute.
And the idl command-line prompt went grey.

ctrl-c did not get them out of this state
reset perspective did not get them out of this locked-up state

I wish I could give you more hints, but its unclear what is causing
this problem.
It is not an infinite loop.

Out of desperation they killed the workbench entirely by clicking on
the little close x for the window.
And then went to Windows XP task manager and killed the idl task.

Has anyone else noted this problem?
Is there another method of getting IDL out of a locked-up state?

Thanks,
Elisha

Report message to a moderator

[Message index]

Locked-up workbench: ctrl-C doesnt work

By: elwood on Thu, 27 March 2008 20:37

Previous Topic:	does principle component=Factor analysis?
Next Topic:	Re: Shapefile 'parts' woes

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 16:11:35 PDT 2025

Total time taken to generate the page: 1.36394 seconds