comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » IDL procedures to get theromdynamic parameters from Soundings
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
IDL procedures to get theromdynamic parameters from Soundings [message #6020] Thu, 11 April 1996 00:00
Sereno A. Barr-Kumara is currently offline  Sereno A. Barr-Kumara
Messages: 7
Registered: August 1995
Junior Member
Is there a place where I can obtain routines to do the folowing
from soundings.

1) Lifting condensation Level
1) Level of Free Convection
2) Convective Available Potential Energy (CAPE)

Hope somebody can help out.

Regards

Barr-Kum

____________________________________________________________ ________
| Sereno A. Barr-Kumarakulasinghe | sbarrkum@ic.sunysb.edu |
| Marine Sciences Research Center | |
| State University of New York | |
| Stony Brook, NY 11794-5000 | |
|___________________________________________________________ ________ |

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Re: Is zero-degree fitting possible?
Next Topic: Re: [Q] how to make mpeg/fli movies in IDL

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Apr 10 10:08:49 PDT 2026

Total time taken to generate the page: 2.08038 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software