comp.lang.idl-pvwave archive: archive » IDL procedures to get theromdynamic parameters from Soundings

Home » Public Forums » archive » IDL procedures to get theromdynamic parameters from Soundings

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

IDL procedures to get theromdynamic parameters from Soundings [message #6020]

Thu, 11 April 1996 00:00

Sereno A. Barr-Kumara is currently offline

Sereno A. Barr-Kumara
Messages: 7
Registered: August 1995

Junior Member

Is there a place where I can obtain routines to do the folowing
from soundings.

1) Lifting condensation Level
1) Level of Free Convection
2) Convective Available Potential Energy (CAPE)

Hope somebody can help out.

Regards

Barr-Kum

____________________________________________________________ ________
| Sereno A. Barr-Kumarakulasinghe | sbarrkum@ic.sunysb.edu |
| Marine Sciences Research Center | |
| State University of New York | |
| Stony Brook, NY 11794-5000 | |
|___________________________________________________________ ________ |

Report message to a moderator

[Message index]

IDL procedures to get theromdynamic parameters from Soundings

By: Sereno A. Barr-Kumara on Thu, 11 April 1996 00:00

Previous Topic:	Re: Is zero-degree fitting possible?
Next Topic:	Re: [Q] how to make mpeg/fli movies in IDL

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 22:23:47 PDT 2025

Total time taken to generate the page: 1.35960 seconds