comp.lang.idl-pvwave archive: archive » Plot according to slopes?

Home » Public Forums » archive » Plot according to slopes?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Plot according to slopes? [message #60203]

Mon, 05 May 2008 06:43

Frank Wang
Messages: 6
Registered: May 2008

Junior Member

Hi all,

I am new with IDL, and recently I was bothered with:

"How to make line plot when you know the slopes(of the lines you are
going to plot) defined at each grid point"?

Physically, we can draw a short line segment at each grid point, link
neighboring segments, and then smooth them. But I simply find it too
tricky to do this with ID(or Matlab). Does anyone have any
suggestions? I would appreciate your help. Or you can tell me which
chapter of the IDL manual should I refer to?

Thank you.

With Regards,
Frank

Report message to a moderator

[Message index]

Plot according to slopes?

By: Frank Wang on Mon, 05 May 2008 06:43

Previous Topic:	Re: array.FIELD reading ascii file - ERROR message???
Next Topic:	Re: Plot according to slopes?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Dec 01 09:06:25 PST 2025

Total time taken to generate the page: 0.80553 seconds