comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Re: interact with iimage from the command line?
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Return to the default flat view Create a new topic Submit Reply
Re: interact with iimage from the command line? [message #60453 is a reply to message #60452] Wed, 21 May 2008 10:05 Go to previous messageGo to previous message
David Fanning is currently offline  David Fanning
Messages: 11724
Registered: August 2001
Senior Member
Keflavich writes:

> Nevermind. I found out that true color is certainly possible for idl
> image display. device,true_color=24 should do it.

Oh, my goodness, you didn't copy someone's start-up file,
did you!? About 80% of the time that will pitch you back
to the 1970's.

If you want to keep using that TV command, you
will have to use the TRUE keyword to tell it how
your 24-bit image is interleaved. (TVIMAGE will
figure all of this out for you.)

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: matrix division
Next Topic: Reading Others Code

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Oct 10 10:44:48 PDT 2025

Total time taken to generate the page: 0.32186 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software