comp.lang.idl-pvwave archive: archive » Vector placement in ENVI

Home » Public Forums » archive » Vector placement in ENVI

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Vector placement in ENVI [message #60515]

Tue, 20 May 2008 09:14

datigis
Messages: 2
Registered: May 2008

Junior Member

Adding a new vector to an existing layer, and selecting polygons or
polyline vertices, then it is possible at this time to right-click and
set the new vector placement, that is you can left-click on a diamond
shape handle that appears near the new vector, drag it to change the
vector placement, and then drop the entire vector as a whole set of
polylines in the new location. If you right-click again, then you
accept the new placement of the vector.
Unfortunately, after accepting the vector, it is not possible to drag
again the whole vector shape with the diamond handle. It is only
possible to drag nodes singularly at the end of polylines and thus
change the geometric shape of the vector.

It would be great if it were possible to obtain the "placement"
diamond handle also for previously existing vectors, and not just for
new ones.

Please help!

Thanks, Datigis.

Report message to a moderator

[Message index]

		Vector placement in ENVI By: datigis on Tue, 20 May 2008 09:14
		Re: Vector placement in ENVI By: datigis on Mon, 26 May 2008 02:23

Previous Topic:	animated png: a new format for scientific animations
Next Topic:	Re: Floating underflow?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 29 01:33:20 PST 2025

Total time taken to generate the page: 0.79928 seconds