comp.lang.idl-pvwave archive: archive » The problem about the '.RESET

Home » Public Forums » archive » The problem about the '.RESET_SESSION' command

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

The problem about the '.RESET_SESSION' command [message #61040]

Thu, 26 June 2008 20:13

duxiyu@gmail.com
Messages: 88
Registered: March 2007

Member

In IDL help, the introduction about this command is below:

"The .RESET_SESSION command resets much of the state of an IDL session
without requiring the user to exit and restart the IDL session."

But I find that there are some different points between the IDL
session after .RESET_SESSION and the restarted one.

If I change the work directory in the session, the .RESET_SESSION
command cannot set the work directory to the default path.

In a restarted session, the current state of the decomposed flag is 1.
I set it to 0 by using 'device, decomposed=0'.
And then run '.reset_session', the current state of the decomposed
flag is still 0 which is different from the restarted session.

Is there a command which can get the same session as a restarted one?

Best regards,
Du Jian

Report message to a moderator

[Message index]

The problem about the '.RESET_SESSION' command

By: duxiyu@gmail.com on Thu, 26 June 2008 20:13

Previous Topic:	Re: polyfill with transparent colors
Next Topic:	Re: How to make the figure change automatically while I selected a new color table?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 15:36:49 PDT 2025

Total time taken to generate the page: 1.25620 seconds