comp.lang.idl-pvwave archive: archive » Using cursor command on the multiple plots in the same page

Home » Public Forums » archive » Using cursor command on the multiple plots in the same page

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Using cursor command on the multiple plots in the same page [message #6199]

Fri, 26 April 1996 00:00

yafeng
Messages: 4
Registered: December 1995

Junior Member

Purpose: Detect the cursor position in multiple plots on one window.

At first, I use !p.multi=[0,2,2] to set the four plot regions.
I plot somethig in each region.
Then I use "cursor, x, y, /down" to know the cursor position.
No matter on which plot I pressed the cursor down,
the values of x, y are always referred to the last plot.

Is there anyway that x, y are referred to their own plot, not the last
one?

Thanks

Yafeng

Report message to a moderator

Previous Topic:	HDF 4.0 under PV-Wave?
Next Topic:	NEED FAST CASH? READ AND TRY THIS!!!!!!

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 12:33:48 PDT 2025

Total time taken to generate the page: 1.44011 seconds