comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » How to control character size freely?
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
How to control character size freely? [message #63612] Wed, 12 November 2008 17:46
xqinshan is currently offline  xqinshan
Messages: 21
Registered: November 2008
Junior Member
Hi, Sometimes the character size are not so good, how to control them?
For example,
1) plot,x,y,xtitle='X',title='TEST' , how to change character size for
"TEST' but not "X"?
2) If I set !p.multi=[0,3,3], character size are very small? How to
change them?
Generally,IDL size is relative value. I wonder if IDL can set
character size to be some value, such as character size=12pt.

Best,

Xqinshan

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Re: 2-d fitting
Next Topic: Re: How to control character size freely?

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Nov 28 12:40:12 PST 2025

Total time taken to generate the page: 0.64206 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software