comp.lang.idl-pvwave archive: archive » Is there a command which could tell a CDF file is good or not?

Home » Public Forums » archive » Is there a command which could tell a CDF file is good or not?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Is there a command which could tell a CDF file is good or not? [message #66131]

Sun, 19 April 2009 14:37

litongmu
Messages: 7
Registered: October 2008

Junior Member

Hi all,

I am trying to run a code to deal with 1200 CDF files. However, some
of them are not good files. When I use certain CDF commands to open or
read them. IDL will return a error message and stop running. Now the
problem is I have so many files. And I do not know which are good,
which are bad. They all look the same size. But I can only tell when
the code stop running. Therefore, I have to rerun the code again after
deleting the bad file it picked out. So is there any command in IDL
which could tell whether a CDF file is good or not. The important
feature is that it can return results based on the judge. And it will
not stop a program from running.
Thanks in advance.

Sincerely

Report message to a moderator

Previous Topic:	=?UTF-8?B?4pmj4pa84pmjIOKWiOKWk+KWiCAgIDE2IHRvIDM1IEFnZSBnaXJscyBwcm9maWxlcyA=?= ♣▼♣ █▓█
Next Topic:	Re: Is there a command which could tell a CDF file is good or not?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 12 10:28:26 PDT 2025

Total time taken to generate the page: 1.52205 seconds