comp.lang.idl-pvwave archive: archive » Re: SCALE3.pro isn't doing it's job

Home » Public Forums » archive » Re: SCALE3.pro isn't doing it's job

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: SCALE3.pro isn't doing it's job [message #67560 is a reply to message #67486]

Fri, 31 July 2009 05:37

Brian Daniel
Messages: 80
Registered: July 2009

Member

It worked! But not with Scale3. I tried adding the range keywords to
AXIS (and I am using /T3D) but it didn't change my nubby axes. So I
used the exact surface command below and adjusted the [XYZ]Range
keywords accordingly. I shall choose to Surface over Scale3 from now
on. Thanks for your help.

FYI, I just bought your book. It rocks. Seriously rocks, and I'm only
on page 102!

On Jul 30, 10:12 pm, David Fanning <n...@dfanning.com> wrote:

>
> SURFACE, DIST(5), /NODATA, /SAVE, XRANGE=[0,100], $
> YRANGE=[-50,50], ZRANGE=[0, max(z)], XSTYLE=1, $
> YSTYLE=1, ZSTYLE=1, CHARSIZE=1.5, $
> POSITION=[0.1, 0.1, 0.95, 0.95, 0.1, 0.95], $
> XTICKLEN=1, YTICKLEN=1, XGRIDSTYLE=1, YGRIDSTYLE=1
> AXIS, XAXIS=1, /T3D, CHARSIZE=1.5, XRANGE=[0,100]
> AXIS, YAXIS=1, /T3D, CHARSIZE=1.5, YRANGE=[-50,50]
>
> Cheers,
>
> David
>
> --
> David Fanning, Ph.D.
> Fanning Software Consulting, Inc.
> Coyote's Guide to IDL Programming:http://www.dfanning.com/
> Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: SCALE3.pro isn't doing it's job By: David Fanning on Thu, 30 July 2009 19:12
		Re: SCALE3.pro isn't doing it's job By: Brian Daniel on Fri, 31 July 2009 05:37

Previous Topic:	Re: enviconvert_file_coordinates
Next Topic:	pixel value to x and y position

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 29 00:44:18 PST 2025

Total time taken to generate the page: 0.72226 seconds