comp.lang.idl-pvwave archive: archive » How to size plots on a postscript device?

Home » Public Forums » archive » How to size plots on a postscript device?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

How to size plots on a postscript device? [message #6880]

Wed, 21 August 1996 00:00

Hans van Leeuwen
Messages: 1
Registered: August 1996

Junior Member

Hello,

Can somebody tell me how to size a combination
of plots prepared with !p.multi such that on a
postscript device, the full printing area can be
used?

I have tried to adjust the printing area with
!p.position, however changing these values
does not help to address the lower half of the
ps page as printing area. !d.x_size or other
device parameter can not be changed because they
are read-only.

In short: How do I use the full paper size of
my printer for ps plots prepared with idl?

Any help on this subject will be appreciated.

greetings

Hans van Leeuwen

============================================================ ============
J.H.M. van Leeuwen
at work: vakgroep wiskunde at home: mgr. van Roosmalenplein 30
Toernooiveld 1 5213 GD 's-Hertogenbosch
6525 ED Nijmegen the Netherlands
the Netherlands tel: +31736147086
tel: +31243652873
fax: +31243652140 |_| |
e-mail: leeuwen@sci.kun.nl | |.\/.|_
============================================================ ============

Report message to a moderator

Previous Topic:	matrix functions expm() & logm()
Next Topic:	Color Bars

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 11:51:10 PDT 2025

Total time taken to generate the page: 0.00841 seconds