comp.lang.idl-pvwave archive: archive » Re: Map projection in ENVI

Home » Public Forums » archive » Re: Map projection in ENVI

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Map projection in ENVI [message #71294]

Wed, 09 June 2010 04:04

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

kamal writes:

> Some distorted type of image. The lat/lon vlaues and the parameter
> values are all assigned to each pixel but the image seems to be, I
> don't know, not correct.

There is probably much in ENVI to improve, but
personally, I feel great confidence in their map
projection software. At least in my case, every
time I have tried to confirm a result that seemed
"strange" to me, the problem turned out to be a
faulty assumption or incomplete knowledge on my
part, rather than a problem with the software.

> Is it possible to regrid the coarse resolution to a higher resolution
> using some interpolation method in ENVI (not in IDL!) and also change
> the map projection?

Regrid to a higher resolution using what information?
If you start with low resolution data, producing high
resolution output is imaginary art, not science. :-)

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: Map projection in ENVI By: David Fanning on Wed, 09 June 2010 04:04
		Re: Map projection in ENVI By: kamal on Wed, 09 June 2010 03:16
		Re: Map projection in ENVI By: David Fanning on Tue, 08 June 2010 05:44
		Re: Map projection in ENVI By: kamal on Fri, 11 June 2010 08:22

Previous Topic:	Calculate streamfunction and velocity potential
Next Topic:	Re: symbol font not expoting correctly to EPS from iplot in OSX

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 06:21:00 PDT 2025

Total time taken to generate the page: 2.56290 seconds