comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado

Home » Public Forums » archive » Help with fsc_plot
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend 
Return to the default flat view Create a new topic Submit Reply
Re: Help with fsc_plot [message #73949 is a reply to message #73861] Wed, 08 December 2010 08:07 Go to previous messageGo to previous message
David Fanning is currently offline  David Fanning
Messages: 11724
Registered: August 2001
Senior Member
David Fanning writes:

> Oh, the hell with it! I'll just add a WINDOW keyword
> to all of these commands so that if you want to see
> a plot, contour, surface, etc in a resizeable graphics
> window, you just set the /WINDOW keyword on the command.
> Check back in about a half hour. :-)

OK, done. Set the Window keyword if you want to display
these graphics commands in a resizable graphics window.

http://www.dfanning.com/programs/fsc_plot.pro
http://www.dfanning.com/programs/fsc_contour.pro
http://www.dfanning.com/programs/fsc_surf.pro

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Saving Large(ish) PDF's with IMAGE() crashes IDL completely
Next Topic: localising IDL programs

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Oct 11 03:07:07 PDT 2025

Total time taken to generate the page: 0.63810 seconds