comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » fitting with asymmetric errors?
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
fitting with asymmetric errors? [message #74285] Fri, 07 January 2011 08:46
Elizabeth is currently offline  Elizabeth
Messages: 1
Registered: January 2011
Junior Member
Hi all,
I'm trying to fit a curve to a data set with asymmetric errors. I
usually use mpfitexpr when fitting, but cannot see a way to input
anything other than symmetric errors (though this is could well be a
problem with my understanding rather than the routine!). If mpfitexpr
is not the task for the job, is there another routine you would
suggest?

Thank you very much for your time! :)
Liz

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: IDL 8, EPS vs. PS graphics
Next Topic: Re: IDL 8, EPS vs. PS graphics

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 13:52:44 PDT 2025

Total time taken to generate the page: 0.00490 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software