comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Command line display format
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Command line display format [message #75773] Wed, 04 May 2011 11:56
Ammar Yusuf is currently offline  Ammar Yusuf
Messages: 36
Registered: October 2010
Member
Hi, so I did this in the command line:
IDL> print, wave_special[2], wave_special[1], wave_special[2]-
wave_special[1]
1260.20 1260.10 0.0999756

I was hoping it would print out 0.10 but it's something really close.
How can I display in my command line the actual values of
wave_special. I know in Matlab you can type format short, format long,
to do it.

Is using the print format the only way to see? Thanks!

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: 3d Visualization
Next Topic: Re: Command line display format

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 11:34:58 PDT 2025

Total time taken to generate the page: 0.00510 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software