comp.lang.idl-pvwave archive: archive » Command line display format

Home » Public Forums » archive » Command line display format

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Command line display format [message #75773]

Wed, 04 May 2011 11:56

Ammar Yusuf
Messages: 36
Registered: October 2010

Member

Hi, so I did this in the command line:
IDL> print, wave_special[2], wave_special[1], wave_special[2]-
wave_special[1]
1260.20 1260.10 0.0999756

I was hoping it would print out 0.10 but it's something really close.
How can I display in my command line the actual values of
wave_special. I know in Matlab you can type format short, format long,
to do it.

Is using the print format the only way to see? Thanks!

Report message to a moderator

[Message index]

Command line display format

By: Ammar Yusuf on Wed, 04 May 2011 11:56

Previous Topic:	3d Visualization
Next Topic:	Re: Command line display format

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 16:20:34 PDT 2025

Total time taken to generate the page: 0.88537 seconds