comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Displaying thicker lines on an image
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Displaying thicker lines on an image [message #76164] Sat, 21 May 2011 06:10
wlandsman is currently offline  wlandsman
Messages: 743
Registered: June 2000
Senior Member
I have been using edge detection algorithms, so i end up with an image with values of 255 on the lines defining the edges, and zeros everywhere else. However, when I display the image, the lines don't show up well, so for display purposes I want to make the lines thicker. If I had created the lines with the PLOT command, I would adjust the THICK keyword. But for an image I think I need an algorithm that will identify neighboring pixels to the existing lines. Thanks, --Wayne

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Re: arrays with different sizes
Next Topic: Re: Errors in the best fit parameters in MPFIT

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Oct 11 02:02:55 PDT 2025

Total time taken to generate the page: 1.28257 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software