comp.lang.idl-pvwave archive: archive » Re: PARTVELVEC procedure not overplotting despite setting over keyword, Trouble with OPLOT

Home » Public Forums » archive » Re: PARTVELVEC procedure not overplotting despite setting over keyword, Trouble with OPLOT

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: PARTVELVEC procedure not overplotting despite setting over keyword, Trouble with OPLOT [message #77085]

Fri, 29 July 2011 05:49

wlandsman
Messages: 743
Registered: June 2000

Senior Member

Note that PARTVELVEC from the Astronomy Library uses Coyote graphics procedures. One can sometimes run into problems with symbols not appearing when mixing OPLOT/PLOTS with Coyote graphics because of the background color, and one should use CGPLOT,/OVER and CGPLOTS instead. I don't think this is your problem (since you specifically set a color) but it is something to keep in mind.

--Wayne

Report message to a moderator

[Message index]

		Re: PARTVELVEC procedure not overplotting despite setting over keyword, Trouble with OPLOT By: wlandsman on Fri, 29 July 2011 05:49
		Re: PARTVELVEC procedure not overplotting despite setting over keyword, Trouble with OPLOT By: David Fanning on Thu, 28 July 2011 06:17

Previous Topic:	Re: Getting x and y positions from a mask
Next Topic:	Re: Unable to get error\exception from IDL wrapper

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 23:22:24 PDT 2025

Total time taken to generate the page: 0.87676 seconds