comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Re: list trouble

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: list trouble [message #79082]

Fri, 27 January 2012 05:22

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Alice Pasetto writes:

> I have a little problem with IDL
> I have a list in which I have two columns: time data in the first and
> in the second I have calibration factors,but some of these last values
> are zero and I don't want to plot out or I can plot them but the
> important things is that these points should not be included in the
> linfit routine...

goodPts = Where(calib NE 0, count)
IF count EQ 0 THEN Message, 'No Valid Calibration Points'
cooef = LinFit(time[goodpts], calib[goodPts], YFIT=yfit)
cgPlot, time, calib, PSYM=2
cgPlot, time[goodPts], yfit, /OPlot, Color='red'

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

Re: list trouble

By: David Fanning on Fri, 27 January 2012 05:22

Previous Topic:	Re: ENVI Classification File
Next Topic:	cgWindow error when I save as a raster image

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 02:26:37 PDT 2025

Total time taken to generate the page: 0.56345 seconds