comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » how to smooth a data set with proper window
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
how to smooth a data set with proper window [message #81413] Sun, 16 September 2012 18:35
Kris is currently offline  Kris
Messages: 2
Registered: September 2012
Junior Member
When I try to make the contour 'beautiful', I have to smooth the data set.
But I have two problems as follows:
1) the smoothed data with SMOOTH function is different from the origin one, dose it make sense to create some data?
2) the data smoothed with MIN_CURVE_SURF function dose not change very much, how to adjust the parameters?

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Is IDL 8.2 Workbench Slow, Too?
Next Topic: weird behavior of Triangulate

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Oct 11 11:02:48 PDT 2025

Total time taken to generate the page: 1.60085 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software