comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Reading Analog input from IDL
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Reading Analog input from IDL [message #81995] Fri, 02 November 2012 01:23
stefanfuglsang is currently offline  stefanfuglsang
Messages: 1
Registered: November 2012
Junior Member
Any suggestions how to access live analog signals from IDL?
I'm thinking of buying an NI-USB-6210 or similar, but how do I read the signals (through a library in a DLL I guess -- I have very little experience in doing this from IDL)? Any limitations on version (I'm running IDL 6.4, but I can upgrade if necessary)

Other suggestions for hardware are also welcome.
Requirements: must run on Windows XP, USB connection, resolution>=12 bit , sample rate ~100 samples/s, +- 1 V range, price preferred less than 1000 Euro


Thanks
Stefan

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: One RETALL is not enough
Next Topic: Re: Widget driven analysis

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 13:33:19 PDT 2025

Total time taken to generate the page: 0.00555 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software