comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » XYOUTS in 3D
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
XYOUTS in 3D [message #83292] Mon, 11 February 2013 14:28
vlk.astro is currently offline  vlk.astro
Messages: 11
Registered: March 2006
Junior Member
Hello,

Is there a way to specify a z-offset to XYOUTS?

I have a complex set of PLOTS calls with /T3D set, and I want to label certain regions of the figure. Unfortunately, XYOUTS does not accept the Z-coordinate, so all the labels are stuck in the XY plane. Is there some alternative to XYOUTS (in IDL 7) that will achieve this?

If not, is there some way to convert an (x,y,z) plotted with PLOTS,/T3D into device or normal coordinates?

Thanks much,
Vinay

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Function compiles (maybe) but cannot be called
Next Topic: Antidote to Doom and Gloom

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sun Oct 12 19:44:26 PDT 2025

Total time taken to generate the page: 0.01444 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software