comp.lang.idl-pvwave archive: archive » Re: How to display single orbits of satellite data in function graphics?

Home » Public Forums » archive » Re: How to display single orbits of satellite data in function graphics?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How to display single orbits of satellite data in function graphics? [message #84109 is a reply to message #84106]

Tue, 30 April 2013 09:56

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Paul van Delst writes:

> And here is my practically line-by-line translation of the above using
> FG. note that I am using "PLOT()" to approximate PLOTS by simply
> overplotting the same point.

My first thought would have been to try to plot all points at once, with
a single Plot() command, without the loop. Did you try that?

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thue. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: How to display single orbits of satellite data in function graphics? By: Jim Pendleton on Tue, 30 April 2013 13:29
		Re: How to display single orbits of satellite data in function graphics? By: Paul Van Delst[1] on Tue, 30 April 2013 13:24
		Re: How to display single orbits of satellite data in function graphics? By: Dick Jackson on Tue, 30 April 2013 11:50
		Re: How to display single orbits of satellite data in function graphics? By: Mark Piper on Tue, 30 April 2013 11:24
		Re: How to display single orbits of satellite data in function graphics? By: Mark Piper on Tue, 30 April 2013 11:18
		Re: How to display single orbits of satellite data in function graphics? By: Mark Piper on Tue, 30 April 2013 11:17
		Re: How to display single orbits of satellite data in function graphics? By: David Fanning on Tue, 30 April 2013 09:56
		Re: How to display single orbits of satellite data in function graphics? By: Paul Van Delst[1] on Tue, 30 April 2013 09:50
		Re: How to display single orbits of satellite data in function graphics? By: David Fanning on Tue, 30 April 2013 09:34
		Re: How to display single orbits of satellite data in function graphics? By: Paul Van Delst[1] on Tue, 30 April 2013 09:24
		Re: How to display single orbits of satellite data in function graphics? By: Paul Van Delst[1] on Wed, 01 May 2013 07:48

Previous Topic:	Re: i cann't open idl because idlde.exe has stopped working.
Next Topic:	How to convert saved postscript file to PNG

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 02:02:59 PDT 2025

Total time taken to generate the page: 0.64261 seconds