comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » calling ANSYS Fluent from IDL
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
calling ANSYS Fluent from IDL [message #84295] Sat, 18 May 2013 15:15
justinclouds is currently offline  justinclouds
Messages: 25
Registered: December 2012
Junior Member
I need to run ANSYS Fluent by calling it from IDL and I am finding no information on how to do this. The objective is to run a monte carlo routine in IDL with inline code that runs several Fluent simulations in a loop. If anybody in the group has any experience with this I would appreciate the help.

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: extract ROI from contours with sub-pixel accuracy
Next Topic: Re: Speeding up xy distance calculations using complex numbers

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 15:17:30 PDT 2025

Total time taken to generate the page: 0.15820 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software