| Re: Adding elements in an Array [message #85996 is a reply to message #85995] |
Mon, 23 September 2013 14:15   |
David Fanning
Messages: 11724 Registered: August 2001
|
Senior Member |
|
|
Mats Löfdahl writes:
> I still don't understand it.
>
> When you evaluate on a grid point, linear interpolation should give the
> same result as nearest neighbor. So if the evaluation point is not the
> center cell of the three here, then what is it?
Oh, man, you see where this is going, don't you? We are about to open an
ENTIRE can of worms over the very simplest question. OK, I turn you back
over to Wayne, who understands flux preservation and the workings of the
Congrid command a whole HELL of a lot better than I do. ;-)
Cheers,
David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thue. ("Perhaps thou speakest truth.")
|
|
|
|