comp.lang.idl-pvwave archive: archive » subscript and superscript in postscript file

Home » Public Forums » archive » subscript and superscript in postscript file

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

subscript and superscript in postscript file [message #94022]

Sat, 24 December 2016 07:10

Krishnakumar M.A
Messages: 19
Registered: March 2013

Junior Member

Hi,

I was trying to print some values came from the code into a plot in postscript format through XYOUTS as below as superscript and subscript.

xyouts,350,45.0,'!4a = '+alp+'!6!E' +alphigh+ '!I'+alplow

The problem is the placement of the superscript/subscript at the end of the "alp" string. I want it to start from the same position above and below the end of "alp" string, but, in the above way, position of subscript is after the superscript (obvious). I know this is a naive question, but it will helpful if there is a way out.

Thanks,
Krishnakumar

Report message to a moderator

[Message index]

		subscript and superscript in postscript file By: Krishnakumar M.A on Sat, 24 December 2016 07:10
		Re: subscript and superscript in postscript file By: Jim Pendleton on Sat, 24 December 2016 07:42
		Re: subscript and superscript in postscript file By: Krishnakumar M.A on Sat, 24 December 2016 12:04

Previous Topic:	Remove the repeated lines in my array...
Next Topic:	Attempt to call undefined procedure/function -- error

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 14:58:49 PDT 2025

Total time taken to generate the page: 0.00182 seconds