comp.lang.idl-pvwave archive: archive » Displaying plots on X-terminals: backing pixmap doesn't get set?

Home » Public Forums » archive » Displaying plots on X-terminals: backing pixmap doesn't get set?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Displaying plots on X-terminals: backing pixmap doesn't get set? [message #995]

Tue, 13 April 1993 09:37

kashyap
Messages: 26
Registered: April 1993

Junior Member

Hi,

I use a Visual TX100M X-terminal (currently with 2-Meg memory) sometimes to
display IDL plots, and for some reason, the backing pixmap does not get set.
So whenever I cover/uncover the plot window, the covered part comes out
blank. It gets rather annoying when one is trying to build up a complicated
plot. I would appreciate any suggestions/hints to avoid this problem.

I have the same problem with ghostview, but that I can live with.

terminal windows, clocks, xload, etc., do NOT exhibit this problem. i.e.,
when I cover an xterm window with another and uncover it, I can still see all
the stuff that was covered.

Please email, I will post a summary.

Vinay (kashyap@oddjob.uchicago.edu)

Report message to a moderator

[Message index]

Displaying plots on X-terminals: backing pixmap doesn't get set?

By: kashyap on Tue, 13 April 1993 09:37

Previous Topic:	Running PV-WAVE on a Xserver
Next Topic:	SOLUTION: Displaying plots on X-terminals: backing pixmap doesn't get set?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 07:51:16 PDT 2025

Total time taken to generate the page: 0.95882 seconds