comp.lang.idl-pvwave archive: archive » Re: Lookin for VRML, DXF or IGES

Home » Public Forums » archive » Re: Lookin for VRML, DXF or IGES

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Lookin for VRML, DXF or IGES [message #11832 is a reply to message #11831]

Sat, 30 May 1998 00:00

davidf
Messages: 2866
Registered: September 1996

Senior Member

Daniel SAGE (daniel.sage@epfl.ch) writes:

> I use the shade_volume and polyshade to create a 3D contour surface and
> I would like to save the result in 3D vectoriel format, for example
> VRML, DXF or IGES.
> Does anyone have a IDL routine for that ?

I don't know if any IDL routines that do this. I do note
that there is a new VRML object in IDL 5.1 which can output
an object graphics hierarchy in the VRML format. Yet another
reason to learn about object graphics. :-)

Cheers,

David
-----------------------------------------------------------
David Fanning, Ph.D.
Fanning Software Consulting
E-Mail: davidf@dfanning.com
Phone: 970-221-0438
Coyote's Guide to IDL Programming: http://www.dfanning.com/

Report message to a moderator

[Message index]

		Re: Lookin for VRML, DXF or IGES By: Leonard Daly on Sat, 30 May 1998 00:00
		Re: Lookin for VRML, DXF or IGES By: davidf on Sat, 30 May 1998 00:00

Previous Topic:	left hand eigenvectors
Next Topic:	Re: Free Advice, was: PostScript and IDL

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 22:33:00 PDT 2025

Total time taken to generate the page: 0.00798 seconds