comp.lang.idl-pvwave archive: archive » Re: Q: How to delete 'active' procedure?

Home » Public Forums » archive » Re: Q: How to delete 'active' procedure?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Q: How to delete 'active' procedure? [message #1291 is a reply to message #1290]

Wed, 11 August 1993 08:51

zawodny
Messages: 121
Registered: August 1992

Senior Member

In article <CBLM6K.Ap8@news.udel.edu> zagar@chester.cms.udel.edu writes:
> I've been getting very frustrated with IDL lately. I keep having to
> quit & re-start pv-wave because I can't DELPROC my procedures after they've
> been used.

pv-wave is NOT IDL !

> I'd like to be able to write a procedure, test it, fix a bug,
> and test it again without having to quit & re-start pv-wave.
>
> Any comments on how that's done ?
>
> -Randy

I usually just .run xxx.pro to kill the old xxx and "compile" the new one.

--
Joseph M. Zawodny (KO4LW) NASA Langley Research Center
Internet: zawodny@arbd0.larc.nasa.gov MS-475, Hampton VA, 23681-0001
Packet: ko4lw@wb0tax.va.usa

Report message to a moderator

[Message index]

		Re: Q: How to delete 'active' procedure? By: harris on Sun, 15 August 1993 14:39
		Re: Q: How to delete 'active' procedure? By: marc on Wed, 11 August 1993 17:09
		Re: Q: How to delete 'active' procedure? By: zawodny on Wed, 11 August 1993 08:51
		Re: Q: How to delete 'active' procedure? By: csillag on Wed, 11 August 1993 09:09

Previous Topic:	Re: 3-D & 2-D plots simultaniously
Next Topic:	Re: Problems with filled contours?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 21:48:37 PDT 2025

Total time taken to generate the page: 3.83938 seconds