comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Unknown error

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Unknown Error [message #14046 is a reply to message #8046]

Mon, 18 January 1999 00:00

L. Charles Burgwardt is currently offline

L. Charles Burgwardt
Messages: 4
Registered: January 1999

Junior Member

I've had procedures use up this "program space" also, but it seems to go
away if i just use the pro command and then compile.

Make the program a compiled procedure by putting "pro procedurename" at the
top, "end" at the bottom, and then compiling it and running it using
"procedurename" instead of "@filename".

Charlie B.

Bertrand Revenaz wrote:

> Hello,
>
> I'm new to both PV-wave and IDL but I have to translate Wave files to
> idle. Nothing fancy just some graphing files to plot the results of a
> model. No interface or anything, it just makes the images. When I try to
> run the files under IDL I get the following message
>
> %prgram code area full
>
> I can't find any reference to it in any of the manuals. Can anybody help
> me...
>
> Bertrand Revenaz
> breven@po-box.mcgill.ca

Report message to a moderator

[Message index]

		Unknown error By: Steven Thiel on Thu, 30 January 1997 00:00
		Re: Unknown Error By: davidf on Mon, 18 January 1999 00:00
		Re: Unknown Error By: L. Charles Burgwardt on Mon, 18 January 1999 00:00

Previous Topic:	Segmentation
Next Topic:	Thick keyword

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Dec 02 04:24:54 PST 2025

Total time taken to generate the page: 0.96337 seconds