comp.lang.idl-pvwave archive: archive » oplot - error in plotting to Z buffer only

Home » Public Forums » archive » oplot - error in plotting to Z buffer only

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

oplot - error in plotting to Z buffer only [message #14249]

Fri, 05 February 1999 00:00

fireman
Messages: 49
Registered: August 1991

Member

Well, I'm stumped.

I have a routine to automatically generate a bunch o'gifs.
Usually it works fine.

On one set of data it fails with the error:

% OPLOT: No valid points, must have at least 2 distinct points

But, but - I *do* have points to plot!
If I run this interactively I can re-enter the command after it gives
the error, and it works fine. (But .con does not)

AND if I plot to an X-window instead of to the Z-buffer (as I usually
do when generating gifs) it runs fine.

Has anyone seen a similar discrepancy?
Is there something I need to know about the Z buffer?

Thanks.

--
---- Gwyn F. Fireman
---- General Sciences Corporation
---- MODIS Characterization Support Team
---- Gwyn.Fireman@gsfc.nasa.gov 301-352-2118

Report message to a moderator

[Message index]

oplot - error in plotting to Z buffer only

By: fireman on Fri, 05 February 1999 00:00

Previous Topic:	READ_TIFF error with 5.2
Next Topic:	Weighted cross correlation routine?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Dec 02 06:45:36 PST 2025

Total time taken to generate the page: 0.40243 seconds