| Re: 3D projection rotation [message #14322 is a reply to message #14236] |
Tue, 09 February 1999 00:00  |
Dave Brennan
Messages: 28
Registered: December 1998
|
Junior Member |
|
|
Thanks for the solution.
However, I found that I had to use REBIN before the second XINTERANIMATE command, otherwise the
window was resized, but the data was not.
I have one further question though,
I use the Voxel_Proj command with a data set of 256x256x128. This produces projection data in a
window of 640x512. However, the window is much larger than the data produced so I would like to
reduce the data output from Voxel_Proj to a smaller matrix to reduce the 'border' around the data. I
have tried the following,
img=voxel_proj(imagebyt,/maximum_intensity,xsize=512,ysize=4 10)
This does reduce the size of the output data , but the projection data, which was central within the
output window is now offset from the centre. How do I reduce the output size whilst keeping the data
central within the window.
thanks for you help
Dave Brennan
David Fanning wrote:
>
> Some of the relevant code is missing here, but I think
> the simplest solution is to just increase the size of
> the XInteranimate window by a factor of two. :-)
>
> XInterAnimate, Set=[currentX*2, currentY*2, frames], /Showload
>
> Be sure this is done *before* you calculate the Scale3
> values, since it will use the size of the current display
> window in its calculations.
>
> Cheers,
>
> David
>
> --
> David Fanning, Ph.D.
> Fanning Software Consulting
> Phone: 970-221-0438 E-Mail: davidf@dfanning.com
> Coyote's Guide to IDL Programming: http://www.dfanning.com/
> Toll-Free IDL Book Orders: 1-888-461-0155
>
> [Note: This follow-up was e-mailed to the cited author.]
|
|
|
|
comp.lang.idl-pvwave archive
Members
Search
Help
Login
Home
