comp.lang.idl-pvwave archive: archive » Re: changing IDLgrAxis and IDLgrSurface ranges

Home » Public Forums » archive » Re: changing IDLgrAxis and IDLgrSurface ranges

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: changing IDLgrAxis and IDLgrSurface ranges [message #17703 is a reply to message #17702]

Tue, 09 November 1999 00:00

davidf
Messages: 2866
Registered: September 1996

Senior Member

Todd Bowers (tbowers@nrlssc.navy.mil) writes:

> My question is in the handleMenuEvents code, how do I tell the surface
> to draw only a limited range of itself. Unfortunately there are no keywords
> like viewXRange, viewYRange, viewZRange to the setProperty method so I can
> tell it that even though the data ranges in x from 0 to 100, just
> realize the surface from 10 to 50. A very ugly solution is to pass the
> dataX, dataY, and dataZ arrays or a reference to them (can't use
> getProperty to retrieve the data), chop them up to the new ranges and stick
> these in new arrays, create a new surface, etc. Hideous.

I think the hideous choice is the only choice in this case. :-(

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting
Phone: 970-221-0438 E-Mail: davidf@dfanning.com
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Toll-Free IDL Book Orders: 1-888-461-0155

Report message to a moderator

[Message index]

		Re: changing IDLgrAxis and IDLgrSurface ranges By: T Bowers on Tue, 09 November 1999 00:00
		Re: changing IDLgrAxis and IDLgrSurface ranges By: davidf on Tue, 09 November 1999 00:00

Previous Topic:	New Drawing Color Object
Next Topic:	changing IDLgrAxis and IDLgrSurface ranges

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 15:17:26 PDT 2025

Total time taken to generate the page: 1.35963 seconds