comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Re: Cannot save MPEG

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Cannot save MPEG [message #18796 is a reply to message #18795]

Sat, 05 February 2000 00:00

davidf
Messages: 2866
Registered: September 1996

Senior Member

Leonid Syrkin (lsyrkin@yahoo.com) writes:

> I opened a window just to see what I am putting into MPEG file.
> The fragment could be:
>
> FOR j=0, 31 DO BEGIN
> READ_PICT,filnm,image
> MPEG_PUT, mpegID, IMAGE=image, FRAME=j
> ENDFOR
>
> Does it make a difference?

I don't know. It would make a difference if your image
was not exactly the size you declared in the MPEG_OPEN
command. I was looking for reasons why you couldn't
write the file. This was the only one that occurred
to me that I thought might be plausible. :-)

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting
Phone: 970-221-0438 E-Mail: davidf@dfanning.com
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Toll-Free IDL Book Orders: 1-888-461-0155

Report message to a moderator

[Message index]

		Re: Cannot save MPEG By: lsyrkin on Sun, 06 February 2000 00:00
		Re: Cannot save MPEG By: davidf on Sat, 05 February 2000 00:00
		Re: Cannot save MPEG By: davidf on Sat, 05 February 2000 00:00

Previous Topic:	Re: editor in IDLDE 5.3 broken?
Next Topic:	thresholding/color question

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 10:12:20 PDT 2025

Total time taken to generate the page: 0.56087 seconds