comp.lang.idl-pvwave archive: archive » Re: global optimization program is available

Home » Public Forums » archive » Re: global optimization program is available

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: global optimization program is available [message #19075 is a reply to message #18936]

Tue, 22 February 2000 00:00

Pavel Romashkin
Messages: 166
Registered: April 1999

Senior Member

David Fanning wrote:

> What next!?
> RSI lowers the price of IDL?

That is as unlikely as it will warm up above 0F outside here, I am
afraid.

>> Did I miss out on something funny?
>
> Unfortunately, no. But it is nice to hear from you
> again. :-)

I know now. I read the Matlab thread. Oh, boy. I was so tempted to write
to it. But it keeps growing at a scary rate even without me. I see you
all folks are all on 5.3 now. My boss brought me a disk with 5.3 here,
too. When I asked, what the key to the software is, he said "What
key?"... Guess how useful that CD is to me now. The 7-min demo mode is
still available, though :-)

Cheers,
Pavel

Report message to a moderator

[Message index]

		Re: global optimization program is available By: Luis Alonso on Thu, 17 February 2000 00:00
		Re: global optimization program is available By: davidf on Tue, 22 February 2000 00:00
		Re: global optimization program is available By: Pavel Romashkin on Tue, 22 February 2000 00:00
		Re: global optimization program is available By: Stein Vidar Hagfors H[1] on Mon, 21 February 2000 00:00
		Re: global optimization program is available By: davidf on Mon, 21 February 2000 00:00
		Re: global optimization program is available By: Stein Vidar Hagfors H[1] on Mon, 21 February 2000 00:00
		Re: global optimization program is available By: Pavel Romashkin on Tue, 22 February 2000 00:00
		Re: global optimization program is available By: davidf on Mon, 28 February 2000 00:00
		Re: global optimization program is available By: Stein Vidar Hagfors H[1] on Mon, 28 February 2000 00:00

Previous Topic:	Low pass filter
Next Topic:	Output to dxf?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 18:04:58 PDT 2025

Total time taken to generate the page: 0.00466 seconds