comp.lang.idl-pvwave archive: archive » Binary Output/Input From/To IDL on PC??????

Home » Public Forums » archive » Binary Output/Input From/To IDL on PC??????

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Binary Output/Input From/To IDL on PC?????? [message #2048 is a reply to message #1973]

Tue, 26 April 1994 01:07

buteau
Messages: 9
Registered: September 1992

Junior Member

Be very careful with the MS Fortran Unformatted Write.
MS Fortran writes data with control blocks and this control blocks are not
the same of other Fortran ( Sun Fortran for example) or Pv Wave.

I had difficulties reading with Pv Wave data written by MS Fortran Unformatted Writes . The only solution I had was to carefully look in the MS manual how this Fortran writes data and control blocks and then with Pv Wave make a byte per byte read of the data to discard the control blocks and to retrieve my data.

Report message to a moderator

[Message index]

		Binary Output/Input From/To IDL on PC?????? By: rlefevre on Tue, 19 April 1994 10:50
		Re: Binary Output/Input From/To IDL on PC?????? By: grunes on Tue, 26 April 1994 05:05
		Re: Binary Output/Input From/To IDL on PC?????? By: buteau on Tue, 26 April 1994 01:07

Previous Topic:	Widget_list and Widget_slider questions
Next Topic:	contour filling

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:39:31 PDT 2025

Total time taken to generate the page: 0.00599 seconds