comp.lang.idl-pvwave archive: archive » Re: lego tiled image (how to make?)

Home » Public Forums » archive » Re: lego tiled image (how to make?)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: lego tiled image (how to make?) [message #22588 is a reply to message #22586]

Wed, 22 November 2000 00:00

Craig Markwardt
Messages: 1869
Registered: November 1996

Senior Member

Ben Tupper <btupper@bigelow.org> writes:
> Hello,
>
> What you describe sounds very much like what I do with Liam Gumley's IMDISP
> procedure. You may control all of the behaviors you now control with the
> SHADE_SURF commands. Soemthing like the following:
>
> IMDISP, merged, Out_Pos = Pos
> (if you need to check for NANs then switch in BYTSCL(merged,/NAN) for merged
> above)
>
> PLOT, lonbins,latbins, Position = Pos, /NoErase

Or, PLOTIMAGE, which does these in one step. It's supposed to be
exactly like a plot command. For astronomy images you can even
display the image "backwards!"

I gotta keep flogging PLOTIMAGE since Liam muscled into my territory
with IMDISP. Liam, don't worry, I have a worthy competitor for
bintools coming soon.

Craig

--
------------------------------------------------------------ --------------
Craig B. Markwardt, Ph.D. EMAIL: craigmnet@cow.physics.wisc.edu
Astrophysics, IDL, Finance, Derivatives | Remove "net" for better response
------------------------------------------------------------ --------------

Report message to a moderator

[Message index]

		Re: lego tiled image (how to make?) By: Craig Markwardt on Wed, 22 November 2000 00:00
		Re: lego tiled image (how to make?) By: Craig Markwardt on Wed, 22 November 2000 00:00
		Re: lego tiled image (how to make?) By: Ben Tupper on Wed, 22 November 2000 00:00

Previous Topic:	Re: lego tiled image (how to make?) (Thank you)
Next Topic:	Multiple comparison test

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 01:35:21 PDT 2025

Total time taken to generate the page: 0.66171 seconds