comp.lang.idl-pvwave archive: archive » Re: Display two images on one position

Home » Public Forums » archive » Re: Display two images on one position

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Display two images on one position [message #28630 is a reply to message #28627]

Wed, 02 January 2002 07:14

Emmler, Oliver
Messages: 14
Registered: May 2001

Junior Member

> But this goes even further afield from "easy" than my
> previous example, so I'm not sure it would meet
> your criteria. :-)

Thanks. I tried using your procedures. The scaling of the colortable/images
will cause the picture to lose details. I think i have to use the following
loop. Is there any way to speed it up ?

FOR x = 0,510 DO BEGIN
FOR y = 0,510 DO BEGIN
IF highlight(x,y) NE 0 THEN TV, highlight(x:x+1,y:y+1),x,y
ENDFOR
ENDFOR

With Best Regards for the new year,

Oliver

Report message to a moderator

[Message index]

		Re: Display two images on one position By: Craig Markwardt on Wed, 02 January 2002 14:57
		Re: Display two images on one position By: Emmler, Oliver on Wed, 02 January 2002 07:14
		Re: Display two images on one position By: David Fanning on Mon, 24 December 2001 09:37
		Re: Display two images on one position By: Emmler, Oliver on Mon, 24 December 2001 00:51
		Re: Display two images on one position By: David Fanning on Sun, 23 December 2001 18:27
		Re: Display two images on one position By: David Fanning on Sun, 23 December 2001 14:57

Previous Topic:	Write_Image
Next Topic:	Re: Display two images on one position : or even three!

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 14:29:26 PDT 2025

Total time taken to generate the page: 1.27870 seconds