comp.lang.idl-pvwave archive: archive » How to move shade

Home » Public Forums » archive » How to move shade_surface axes?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How to move shade_surface axes? [message #29656 is a reply to message #29534]

Thu, 28 February 2002 08:54

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Steve Smith<steven_smith> (nobody@nowhere.com) writes:

> however, it requires idl 5.3 to run :( , I have been maintaining my license
> up untill a few months age, but never upgraded because of the GIF issue (GIF
> was removed from IDL till 5.5, correct?). I missed the boat (maintenance is
> expired) to go to 5.5, but I've got the media for 5.3, is it possible
> to add only the component of 5.3 that is required?

Oh, just remove that check from the code. The program
will run in IDL 5.3. I just used some useful PRINTER
keywords that were introduced in IDL 5.4. So, as long
as you don't want to print anything... :-)

Cheers,

David

P.S. You *can* print, you will just have to work
around those darn useful keywords.

--
David W. Fanning, Ph.D.
Fanning Software Consulting
Phone: 970-221-0438, E-mail: david@dfanning.com
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Toll-Free IDL Book Orders: 1-888-461-0155

Report message to a moderator

[Message index]

		How to move shade_surface axes? By: nobody@nowhere.com (S on Wed, 27 February 2002 16:34
		Re: How to move shade_surface axes? By: David Fanning on Thu, 28 February 2002 08:54
		Re: How to move shade_surface axes? By: nobody@nowhere.com (S on Thu, 28 February 2002 08:26

Previous Topic:	Re: Vectorizing Code
Next Topic:	Plotting error in IDL 5.5

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 30 15:05:16 PST 2025

Total time taken to generate the page: 0.48283 seconds