comp.lang.idl-pvwave archive: archive » Low quality with 'IDLgrClipboard' object

Home » Public Forums » archive » Low quality with 'IDLgrClipboard' object

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Low quality with 'IDLgrClipboard' object [message #30886 is a reply to message #30859]

Thu, 23 May 2002 08:31

Pavel A. Romashkin
Messages: 531
Registered: November 2000

Senior Member

I think it has to do with the way previews are created. I have seen that
and was concerned but the printouts were ok.
On the other hand, the colors never came out right... But I have lost my
hope with regard to that a long time ago, after realizing that I can
write 3000 lines of data processing code in the time I need to make one
plot to look nice. From then on, it is Adobe Illustrator that I use to
see what the colors are going to look like.
Cheers,
Pavel

Georg Wiora wrote:
>
> Hi,
>
> I tried to draw an IDLgrPlot object to an IDLgrClipboard object using
> OClip->draw,oPlot,VECTOR=1
>
> The clipboard contained an EMF/WMF graphics after that operation. But with the clipboard viewer and after inserting this object
> into a graphics program, it looked quite blocky with big pixels. Obviously it was not inserted as a vector graphics, but as a
> scalable bitmap.
>
> Is that a documentation problem or am i using wrong parameters? The documentation says, that the graphics is converted to vector
> primitives, but it does not look like that.
> Increasing the resolution of the Clipboard object does only create finer lines, but not a higher resolution result.
>
> Who knows about that?
>
> Regards,
>
> Georg Wiora
> DaimlerChrysler AG
> Research Center Ulm

Report message to a moderator

[Message index]

		Low quality with 'IDLgrClipboard' object By: Georg Wiora on Sun, 19 May 2002 08:55
		Re: Low quality with 'IDLgrClipboard' object By: Karl Schultz on Thu, 23 May 2002 15:11
		Re: Low quality with 'IDLgrClipboard' object By: Pavel A. Romashkin on Thu, 23 May 2002 08:31

Previous Topic:	Object programming with data...
Next Topic:	give me any advice on volume visualization

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 12:07:01 PDT 2025

Total time taken to generate the page: 2.40044 seconds