comp.lang.idl-pvwave archive: archive » Re: CW

Home » Public Forums » archive » Re: CW_Animate procedure...

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: CW_Animate procedure... [message #32166 is a reply to message #32165]

Thu, 12 September 2002 10:19

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

M (mrmanish@bigfoot.com) writes:

> I'm writing a program that uses the CW_ANIMATE procedure to animate plots,
> then write them to an mpeg file. This is all working fine, but when i come
> to write the mpeg (via the save button in the widget), it only writes it at
> full speed (frame rate).... :-( I can view it fine at (say) 30% speed,
> but saving it as mpeg at that speed is a problem.
>
> I was wondering, is there a way to write the mpeg at a specified % frame
> rate, ie 30% of full speed?

No. :-)

Cheers,

David

--
David W. Fanning, Ph.D.
Fanning Software Consulting, Inc.
Phone: 970-221-0438, E-mail: david@dfanning.com
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Toll-Free IDL Book Orders: 1-888-461-0155

Report message to a moderator

[Message index]

		Re: CW_Animate procedure... By: Manish on Fri, 13 September 2002 02:39
		Re: CW_Animate procedure... By: Rick Towler on Thu, 12 September 2002 11:18
		Re: CW_Animate procedure... By: Manish on Thu, 12 September 2002 10:21
		Re: CW_Animate procedure... By: David Fanning on Thu, 12 September 2002 10:19

Previous Topic:	Re: External c calls broken in IDL 5.5
Next Topic:	Re: IDLWAVE 4.15 Release -- idlwave.org

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 16:15:54 PDT 2025

Total time taken to generate the page: 1.19798 seconds