comp.lang.idl-pvwave archive: archive » CW

Home » Public Forums » archive » CW_Animate procedure...

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

CW_Animate procedure... [message #32167]

Thu, 12 September 2002 10:03

Manish
Messages: 20
Registered: April 2001

Junior Member

Hi all,

I'm writing a program that uses the CW_ANIMATE procedure to animate plots,
then write them to an mpeg file. This is all working fine, but when i come
to write the mpeg (via the save button in the widget), it only writes it at
full speed (frame rate).... :-( I can view it fine at (say) 30% speed,
but saving it as mpeg at that speed is a problem.

I was wondering, is there a way to write the mpeg at a specified % frame
rate, ie 30% of full speed?

Many thanks in advance,

Manish.

--

Report message to a moderator

[Message index]

CW_Animate procedure...

By: Manish on Thu, 12 September 2002 10:03

Previous Topic:	Re: Ascii-import
Next Topic:	IDL Primer

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 10:15:54 PDT 2025

Total time taken to generate the page: 0.80058 seconds