comp.lang.idl-pvwave archive: archive » Re: Un-setting /ENCAPSULATED PostScript

Home » Public Forums » archive » Re: Un-setting /ENCAPSULATED PostScript

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Un-setting /ENCAPSULATED PostScript [message #3459]

Wed, 01 February 1995 07:20

thompson
Messages: 584
Registered: August 1991

Senior Member

keith@guinness.tmc.edu (Keith Horton) writes:

> A quick question -

> With IDL 3.6.1a running under Solaris 2.2,, I have no problem writing
> PostScript output. Occasionally, though, I want encapsulated PostScript
> output, which also works fine.

> The problem I have is that once I have written something out as encapsulated PostScript, how do I get the device to return to standard
> PostScript? I usually will return the device to 'X', but then later, if
> I want to print out a PostScript plot (non-encapsulated) and set_plot,'PS',
> the device is still set to encapsulated.

> If I've missed something in the manual or if anyone has suggestions,
> I'd appreciate hearing. Right now, I either save all my encapsulated
> stuff until the end of a session or I have to exit IDL and restart it
> to get it reset. This shouldn't be (it seems to me).

Use

DEVICE, ENCAPSULATED=0

To turn encapsulation off.

Bill Thompson

Report message to a moderator

[Message index]

Re: Un-setting /ENCAPSULATED PostScript

By: thompson on Wed, 01 February 1995 07:20

Previous Topic:	clustering algorithms
Next Topic:	Re: IDL contouring question

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 15:41:23 PDT 2025

Total time taken to generate the page: 1.52481 seconds