comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado

Home » Public Forums » archive » Passing file LUN to C routine
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend 
Return to the default flat view Create a new topic Submit Reply
Re: Passing file LUN to C routine [message #35118 is a reply to message #35065] Mon, 12 May 2003 08:25 Go to previous messageGo to previous message
Stein Vidar Hagfors H[2] is currently offline  Stein Vidar Hagfors H[2]
Messages: 28
Registered: October 2002
Junior Member
Ben Tupper <btupper@bigelow.org> writes:

[..]
> (1) pass C the LUN and have the C write each frame: best rate about 15
> frames per second (fps)
>
> (2) pass C a predefined array into which it stores the latest frame
> and return to IDL, then have IDL store the frame: best rate about 15
> fps
>
> No difference!
>
> Each of these are performed in a event driven loop where the events
> are simple timer events with TIMER = verySmallValue. I think I'll try
> it in just a simple loop for fun.
>
>
> Ultimately, I would like to access the video at full frame rate (30
> fps) - not that I need all the frames, but rather I can be sure I am
> getting the every Nth frame. I seem to have other problems right now;
> if I have C grab N frames as fast as it can without sending each frame
> back to IDL
> then I see frame rates as high as 22.5 fps. Hmmm. The promotional
> stuff that came with the frame grabber says I can get full frame rate.
> Dang.

With your problem above (22.5 fps max), are you still writing to disk?
Uncompressed, full-framerate video to disk is quite a challenge for a
number of hardware configurations...

--
------------------------------------------------------------ --------------
Stein Vidar Hagfors Haugan
ESA SOHO SOC/European Space Agency Science Operations Coordinator for SOHO

NASA Goddard Space Flight Center, Tel.: 1-301-286-9028
Mail Code 682.3, Bld. 26, Room G-1, Cell: 1-240-354-6066
Greenbelt, Maryland 20771, USA. Fax: 1-301-286-0264
------------------------------------------------------------ --------------
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: bug(s) in IDL5.6?
Next Topic: RFC 1: Common functions for beginners

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Oct 11 14:52:50 PDT 2025

Total time taken to generate the page: 1.78729 seconds