comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Re: Flow3 procedure

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Flow3 procedure [message #39325 is a reply to message #39294]

Sat, 15 May 2004 16:43

eoraptor
Messages: 5
Registered: January 2004

Junior Member

I'm trying to help Adhara get her flow velocity data to plot using
FLOW3.

FLOW3, Vx, Vy, Vz [,ARROWSIZE=value] [,/BLOB] [,LEN=value]
[,NSTEPS=value] [,NVECS=value] [,SX=vector,SY=vector,SZ=vector]

She has 3 float arrays named Vx, Vy, and Vz that are of dimensioned
(90,360,360). Vx contains the magnitude of the flow vector in the x
direction, Vy is the magnitude in the y direction, etc.

The actual values in the arrays Vx, Vy, and Vz are almost all zero.
The few values that are non-zero are +/- in the range of e-005.

Since most of the values in her arrays are zero, should she be using
WHERE to extract out the non-zero magnitudes before calling FLOW3?
The arrays of SX, SY, and SZ in FLOW3 could be used to give the x,y,z
coordinates of the non-zero magnitudes, right?

Thanks,
Richard

Report message to a moderator

[Message index]

		Re: Flow3 procedure By: David Fanning on Thu, 06 May 2004 12:01
		Re: Flow3 procedure By: eoraptor on Sat, 15 May 2004 16:43
		Re: Flow3 procedure and WHERE By: adharac on Sun, 23 May 2004 09:32
		Re: Flow3 procedure By: adharac on Thu, 13 May 2004 11:48

Previous Topic:	will pay
Next Topic:	Re: Extremely Strange Program Behavior

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 00:10:38 PDT 2025

Total time taken to generate the page: 1.65312 seconds